C2020-A-C27

Made in the UK, O.L.E started manufacturing tank gauges back in 2001, O.L.E. became part of HYTEK in 2021. The O.L.E. range is designed, assembled and tested in the UK at HYTEK. Why buy O.L.E. tank gauges. Suits all shapes of tanks. Well proven reliable technology. ATEX certified versions are available. Consistent accuracy of +/-1% (C2020/Z2000) or +/-0.25% (T5020/Z5020).

Tank probes are electronic pressure sensors with a 1" BSPT male fitting and are recommended to be suspended 50mm from the bottom of the tank. This C2020 kit includes the tank gauge housing, tank pressor sensor with 1"tank adaptor.

Key Features and Benefits:

• Suitable with diesel, HVO, biodiesel, AdBlue®, water & antifreeze
• Suits tanks 5m - 10m high
• Other kits available for 03m - 3m (C2020-A-C23) & 3m -5m high tanks (C2020-A-C25)
• Complete kit includes tank gauge & tank probe (pressure sensor)
• Accuracy +/-1% of tank capacity (do not confuse with other lower cost and lower accuracy gauges that are +/-1% of full-scale, on a 4m high tank these other gauges can give a discrepancy of +/- 40mm)
• Can be set up from the front panel
• High & low level sounder
• LCD display flashes when alarmed
• Electronic display with backlight (turns off after 1 hour)
• 1 gauge required per tank
• Weatherproof to IP55
• Gives continuous readout in litres & shows a % bar
• Power supply can be 230V, 110V or 24VDC
• Includes 4-20mA output. Can connect to a BMS (building management system)

Options:

• Choose bund probe/level switch (B8)
• If using the bund probe for AdBlue®, water or antifreeze choose (B8-ADBLUE)
• Water bottom sensor (T4020-B2)
• If extending the probe cable on non ATEX O.L.E gauges low loss cable must be used (CABLE-4-BLACK)
• Probe cable can be extended to 100m (CABLE-4-BLACK)
• We can calibrate your gauge within 24 hours of receiving our tank questionnaire (CALIB-C2020)
• AdBlue^® is a trademark of the Verband der Automobilindustrie e.V. (VDA). HTTPS://WWW.VDA.DE/DE